<div><p>The experiments were designed to test the combined effects of two CO<sub>2</sub> concentrations, four temperatures, and three light intensities on growth and photophysiology of the cyanobacterium <em>Synechococcus elongatus</em> CCMP1629 in a multifactorial design. Two CO<sub>2</sub> concentrations were tested: 410 ppm, and 1000 ppm. For each CO<sub>2</sub> concentration, four temperatures were tested: 20°C, 28°C, 36°C, and 44°C. Within each temperature, three light levels were tested: sub-optimum irradiance (SOI) intensity of 50 umol photons · m<sup>-2</sup> · s<sup>-1</sup>, optimum irradiance (OI) intensity of 230 umol photons · m<sup>-2</sup> · s<sup>-1</sup> and extreme Irradiance (EI) intensity of 600 umol photons · m<sup>-2</sup> · s<sup>-1</sup>. All lights were set at a 12 h day: 12 h dark cycle. For logistical reasons, experiments were partially conducted in series, with all light treatments at all four temperatures running simultaneously. This was repeated for each CO<sub>2</sub> concentration.</p>
<p>Experiments were conducted in Multicultivator MC-1000 OD units (Photon Systems Instruments, Drasov, Czech Republic). Each unit consists of eight 85 ml test-tubes immersed in a thermostated water bath, each independently illuminated by an array of cool white LEDs set at specific intensity and timing. A 0.2um filtered CO<sub>2</sub>-air mix (Praxair Distribution Inc.) was bubbled through sterile artificial seawater, and the humidified gas mix was supplied to each tube via gentle sparging through a 2um stainless steel diffuser. Flow rates were gradually increased over the course of the incubation to compensate for the DIC uptake of actively growing cells, and ranged from <0.04 Liters per minute (LPM) at the start of the incubations to 0.08 LPM in each tube after 2 days. For each CO<sub>2</sub> and temperature level, replication was achieved by incubating three tubes at sub-optimum light intensities, two tubes at optimum light intensity, and three tubes at extreme light intensities. Each experiment was split into two phases: An acclimation phase spanning 3 days, was used to acclimate cultures to their new environment. Pre-acclimated, exponentially-growing cultures were then inoculated into fresh media and incubated through a 3-day experimental phase during which assessments of growth, photophysiology, and nutrient cycling were carried out daily. All sampling started 5 hours into the daily light cycle to minimize effects of diurnal cycles.</p>
<p>Experiments were conducted with artificial seawater (ASW) prepared using previously described methods (Kester et. al 1967), and enriched with nitrate (NO<sub>3</sub>), and phosphate (PO<sub>4</sub>), at levels ensuring that the cultures would remain nutrient-replete over the course of the experiment. Trace metals and vitamins were added as in <em>f/2</em> (Guillard 1975). The expected DIC concentration, and pH of the growth media was determined for the different pCO<sub>2</sub> and temperatures using the CO2SYS calculator (Pierrot et al. 2006), with constants from Mehrbach et al. (1973, refit by Dickson & Millero 1987), and inputs of temperature, salinity, total alkalinity (2376.5 umol · kg<sup>−1</sup>), pCO<sub>2</sub>, phosphate, and silicic acid. DIC levels in ASW at the start of each phase of the experiments were manipulated by the addition of NaHCO<sub>3</sub>, and was then maintained by bubbling a CO<sub>2</sub>-Air mix through the cultures over the course of the experiments. The pH of the growth media was measured spectrophometrically using the m-cresol purple method (Dickson 1993), and adjusted using 0.1N HCl or 0.1M NaOH. The media was distributed into 75 ml aliquots and each aliquot was inoculated with the <em>S. elongatus</em> CCMP 1629 (SE1629) stock culture at the start of the experiments.</p>
<p><strong>Dissolved Inorganic Carbon (DIC) measurements:</strong></p>
<p>DIC was measured in freshly prepared media, and at the end of the experiment phase. 25 ml of the sample was siphoned into clean glass serum vials, fixed with HgCL2 (0.035 % final conc. v/v), and sealed with butyl rubber septa. Samples were stored at 4°C until analyzed. Prior experiments had confirmed that no gas exchange, and/or change in DIC occurred during sample storage for up to 30 days using this method. Total dissolved inorganic carbon (TCO2) samples were analyzed using an automated infrared inorganic carbon analyzer (AIRICA). The AIRICA-23 (MARIANDA, Kiel, Germany), is a high precision instrument used to measure total dissolved inorganic carbon in seawater. The system uses a high precision syringe and a mass flow controller to deliver a known volume of sample into a stripper where it is then acidified, converting the inorganic carbon species into CO2 and delivered under constant flow to nondispersive infrared detector. The CO2 is then carried using an inert reference gas (N2) into a LICOR-7000 that measures pCO2 using the difference in infrared absorbance between a sample and reference cell. The pCO2 is recorded over time and integrated by the AIRICA software. This integrated value is proportional to the amount of dissolved inorganic carbon evolved from the sample and converted to carbon units using a conversion factor (CT Factor). The CT Factor is determined by calibration of the system against a certified reference material of known value (Dickson et al. 2007. Guide to Best Practices for Ocean CO2 Measurements). The value is converted to gravimetric units (umol/kg) using the volume, temperature and salinity of the sample. In order to check for analytical stability of the system throughout a run, a certified reference material is used in between every 5 samples. Replicate DIC measurements were averaged.</p>
<p><strong>Problem Report: </strong><br />
Target pH calculations were accidentally made for 25°C, so that the actual carbonate system in temperature treatments other than 25°C were vastly different from target.</p></div>
Series 4A: DIC
<div><p>The experiments in Series 4A were designed to test the combined effects of two CO2 concentrations, four temperatures, and three light intensities on growth and photophysiology of the cyanobacteria Synechococcus elongatus CCMP1629 in a multifactorial design. This dataset reports the Dissolved Inorganic Carbon (DIC) levels measured during the experiments.</p></div>
Series 4A: DIC
<div><p><strong>BCO-DMO Processing Notes:</strong><br />
- added conventional header with dataset name, PI name, version date<br />
- modified parameter names to conform with BCO-DMO naming conventions</p></div>
807010
Series 4A: DIC
2020-03-26T14:23:33-04:00
2020-03-26T14:23:33-04:00
2023-07-07T16:10:26-04:00
urn:bcodmo:dataset:807010
Series 4A: Multiple stressor experiments on Synechococcus elongatus (CCMP1629) – Dissolved Inorganic Carbon (DIC)
The experiments were designed to test the combined effects of two CO2 concentrations, four temperatures, and three light intensities on growth and photophysiology of the cyanobacteria Synechococcus elongatus CCMP1629 in a multifactorial design. This dataset contains measurements of Dissolved Inorganic Carbon (DIC) made over the course of the experiments.
false
Passow, U., Laws, E., D'Souza, N. (2020) Series 4A: Multiple stressor experiments on Synechococcus elongatus (CCMP1629) – Dissolved Inorganic Carbon (DIC). Biological and Chemical Oceanography Data Management Office (BCO-DMO). (Version 1) Version Date 2020-03-26 [if applicable, indicate subset used]. doi:10.26008/1912/bco-dmo.807010.1 [access date]
true
1
10.26008/1912/bco-dmo.807010.1
false
2020-08-31
2020-03-26
Datapackage.json
Frictionless Data Package
https://www.bco-dmo.org/dataset/807010/datapackage.json
application/vnd.datapackage+json
PDF
https://www.bco-dmo.org/dataset/807010/Dataset_description.pdf
application/pdf
ISO 19115-2 (NOAA Profile)
https://www.bco-dmo.org/dataset/807010/iso
application/xml
http://www.isotc211.org/2005/gmd-noaa
Dublin Core
https://www.bco-dmo.org/dataset/807010/dublin-core
application/xml
http://purl.org/dc/elements/1.1/
807010
http://lod.bco-dmo.org/id/dataset/807010
2019-07 - 2019-08
2019-07
--07
2019
2019-08
--08
2019