Data were flagged using the SeaDataNet quality flag scheme recommended by GEOTRACES (https://www.geotraces.org/geotraces-quality-flag-policy/) and described below. Notes specific to the application of these flags to this dataset are noted in brackets […].

0: No Quality Control: No quality control procedures have been applied to the data value. This is the initial status for all data values entering the working archive. [Not used].

1: Good Value: Good quality data value that is not part of any identified malfunction and has been verified as consistent with real phenomena during the quality control process. [See Table 1 for blank and certified reference material values obtained in this study].

2: Probably Good Value: Data value that is probably consistent with real phenomena, but this is unconfirmed or data value forming part of a malfunction that is considered too small to affect the overall quality of the data object of which it is a part. [Used when no replicate measurements were available to check the quality of the data].

3: Probably Bad Value: Data value recognized as unusual during quality control that forms part of a feature that is probably inconsistent with real phenomena. [Used when all replicate measurements were too high to be consistent with real phenomena].

4: Bad Value: An obviously erroneous data value. [Not used].

5: Changed Value: Data value adjusted during quality control. Best practice strongly recommends that the value before the change be preserved in the data or its accompanying metadata. [Not used].

6: Value Below Detection Limit: The level of the measured phenomenon was less than the limit of detection (LOD) for the method employed to measure it. The accompanying value is the detection limit for the technique or zero if that value is unknown. [Values below detection are reported as 0.00 µM in the data file. Detection limits for each parameter are listed in the “methods and sampling” section of this form].

7: Value in Excess: The level of the measured phenomenon was too large to be quantified by the technique employed to measure it. The accompanying value is the measurement limit for the technique. [Not used].

8: Interpolated Value: This value has been derived by interpolation from other values in the data object. [Not used].

9: Missing Value: The data value is missing. Any accompanying value will be a magic number representing absent data [When sample was not collected the notation ‘na’ for ‘not applicable’ was used; when sample collected but there is no result for this parameter, the notation ‘NDA’ for ‘no data available’ was used].

A: Value Phenomenon Uncertain: There is uncertainty in the description of the measured phenomenon associated with the value such as chemical species or biological entity. [Not used.]