Dataset: Dissolved organic Fe-binding ligand data from the FRidge (GA13) expedition
View Data: Data not available yet
Data Citation:
Bundy, R. M., Hoffman, C. L. (2024) Dissolved organic Fe-binding ligand data from the FRidge (GA13) expedition on RRS James Cook (cruise JC156) from December 2017 to February 2018. Biological and Chemical Oceanography Data Management Office (BCO-DMO). (Version 1) Version Date 2024-03-21 [if applicable, indicate subset used]. http://lod.bco-dmo.org/id/dataset/923065 [access date]
Terms of Use
This dataset is licensed under Creative Commons Attribution 4.0.
If you wish to use this dataset, it is highly recommended that you contact the original principal investigators (PI). Should the relevant PI be unavailable, please contact BCO-DMO (info@bco-dmo.org) for additional guidance. For general guidance please see the BCO-DMO Terms of Use document.
Spatial Extent: N:37.29 E:-32.28 S:26.03 W:-45.12
North Atlantic Mid-Atlantic Ridge (~ 29N, -40E)
Project:
Are strong ligands and dissolved iron tightly coupled in hydrothermal systems?
(organic iron ligands in hydrothermal systems)
Principal Investigator:
Randelle M. Bundy (University of Washington, UW)
Co-Principal Investigator:
Colleen L. Hoffman (University of Washington, UW)
BCO-DMO Data Manager:
Shannon Rauch (Woods Hole Oceanographic Institution, WHOI BCO-DMO)
Version:
1
Version Date:
2024-03-21
Restricted:
No
Validated:
No
Current State:
Data not available
Dissolved organic Fe-binding ligand data from the FRidge (GA13) expedition on RRS James Cook (cruise JC156) from December 2017 to February 2018
Abstract:
Samples were collected as part of the 2017-2018 U.K. GEOTRACES GA13 section cruise along the Mid-Atlantic Ridge (Cruise JC156 on RRS James Cook). Water samples from 11 venting and near venting locations were collected using a Seabird 911 conductivity, temperature, and depth (CTD) titanium rosette using conducting Kevlar wire with an oxidation-reduction potential (ORP) sensor to detect plumes. Teflon coated OTE (Ocean Test Equipment) bottles were pressurized to approximately 7 psi with 0.2 μm filtered air using an oil-free compressor. A Sartobran 300 (Sartorius) filter capsule (0.2 μm) was used to collect filtered seawater samples into clean 250 mL LDPE sample bottles. Bottles and caps were rinsed 3 times with the filtered sample before being filled. Samples were stored frozen at -20°C for organic iron-binding ligand characterization by voltammetry using competitive ligand exchange adsorptive cathodic stripping voltammetry. All dissolved organic iron-binding ligand samples were measured with a BASi controlled growth mercury electrode with an Ag/AgCl¬- reference electrode and platinum auxiliary electrode (Bioanalytical Systems Incorporated) using previously established methods for forward titrations (Buck et al., 2015, 2018; Bundy et al., 2018; Abualhaija and van den Berg, 2014; Hawkes et al., 2013 (Planet. Sci. Lett.)). Reverse titrations (Hawkes et al., 2013 (Anal. Chim. Acta)) were completed on 10 samples from Broken Spur, and TAG hydrothermal vent fields with dissolved iron concentrations between 19.01-90.25 nM.